The SpyVerter is a high performance upconverter that enables HF reception on SDR’s that aren’t able to tune directly to HF frequencies. Like any upconverter it works by converting those lower HF frequencies ‘up’ into a higher frequency range that is actually receivable by the SDR.
Back in December 2015 when the SpyVerter first came out we reviewed the unit and found that it was probably the best and highest value upconverter on the market. It was priced at a similar or cheaper price to competitors, came in a metal enclosure and had excellent performance. The main reason for its high performance is due to the architecture. While most upconverters on the market like the ham-it-up use an ADE-1 double balanced mixer component, the SpyVerter instead uses an H-mode mixer design. This design is harder to engineer, but it provides better dynamic range meaning that strong signals are less likely to overload the upconverter.
The SpyVerter was recently given a refresh, and the SpyVerter R2 is now available. The changes are small and are mostly centered around the clock. The oscillator is now a 24 MHz 0.5 PPM TCXO, run through a SI5351 clock generator to produce the 120 MHz upconversion frequency. A new onboard microcontroller programs the SI5351 on power up.
This change in clock design also now allows you to connect a 10 MHz reference frequency if ultra stable, or phase coherent frequency operation is required. A u.FL connector is provided next to the output SMA connector on the PCB for connecting a 10 MHz reference. Unfortunately there is no breakout hole in the metal enclosure, meaning that you’ll need to drill your own hole in the enclosure to get the u.FL clock cable out. Few people will need this feature however, as thanks to the 0.5 PPM TCXO stock frequency stability is now excellent.
The new design also uses less power, only drawing 10 mA of current compared to 47 mA in the SpyVerter R1. It also has 12 dB lower local oscillator leakage meaning that the gains might be able to be pushed slightly higher without overload. Once again, just like with the SpyVerter R1 the R2 is also powered via the bias tee on the Airspy, and so is compatible with the bias tee on our RTL-SDR V3 dongles.
There’s also an interesting mod that can be performed with the SpyVerter R2. The LO frequency can be modded to run at 58 MHz instead of 120 MHz. 58 MHz is just low enough to avoid the broadcast FM band, and the lower frequency allows the switches used in the H-mode design to run at a lower frequency. This results in an insertion loss better by about 3 dB’s and less LO leakage meaning that the RF gains can be pushed higher. The main disadvantage to this mod is that the lowest input frequency will only be 28 MHz. The mod details don’t seem to be published yet, but we’ll update this post once they are.
The cost of the SpyVerter R2 remains the same as before at $49 USD. Compared to the Ham-It-Up v1.3 which costs $41.95 USD and does not come with an enclosure or TCXO, the SpyVerter still seems to be the best value. Currently you can buy one internationally from iTead who ship from China, at Airspy.us for US customers, and there are several European distributors linked on the Airspy website.
Disclaimer: The SpyVerter R2 was sent by the Airspy team to us for free in exchange for an honest review.